Traditional Mass Concrete Underpinning: The Bay Method
Traditional mass concrete underpinning deepens existing strip footings by transferring wall loads onto firm subsoil strata below. Structural engineers divide the affected wall into numbered segments, typically 1.0 metre wide, using a hit-and-miss sequence such as 1-4-2-5-3.
Workers excavate Bay 1 beneath the existing foundation, construct timber formwork shuttering, and pour high-strength C35 designated concrete. A 50mm gap left beneath the old footing is later rammed with semi-dry, low-shrinkage cement mortar (dry pack) to transfer structural loads without settlement before adjacent bays are dug.
| Underpinning Method | Subsoil Condition | Average Cost / Metre | Suitable Depth |
| Mass Concrete Bays | Firm cohesive clay or stable chalk | £1,600 - £2,400 | 1.0m to 2.5m depth |
| Mini-Piled Needle Beams | Deep soft clay or variable fill | £2,500 - £3,600 | 3.0m to 12.0m depth |
| Cantilever Piling | Restricted boundary lines without neighbour access | £2,800 - £4,000 | 3.0m to 10.0m depth |
| Polyurethane Resin | Minor localized foundation settlement | £1,200 - £1,800 | Shallow slab levelling |
- Hit-and-miss sequence: Excavating alternate bays prevents whole-wall settlement.
- Dry pack packing: 1:3 cement-sand mortar rammed tightly with wooden drift tools.
- Curing time: Concrete bays must cure for 48 hours before dry packing begins.
- Load transfer: Shuttering remains in place until adjacent concrete reaches full design strength.
Mini-Piled Underpinning for Difficult Subsoils
Where load-bearing strata lie beyond 2.5 metres deep or restricted access prevents manual digging, mini-piled underpinning offers an efficient solution. Specialist drilling rigs drive steel cased piles or continuous flight auger (CFA) piles into firm bedrock or dense gravel.
Once piles are cast, builders core drill pockets through existing brickwork to install reinforced concrete needle beams. These beams span across the piles, locking the existing wall into the deep foundation system.
Building Regulations Sign-Off and Party Wall Notices
Underpinning constitutes major structural work regulated under Part A of the Building Regulations. Building control officers must inspect each excavated bay prior to concrete pouring, verifying subsoil bearing capability.
If underpinning occurs along a boundary shared with an adjoining property, homeowners must serve a formal Section 6 notice under the Party Wall Act at least one month before excavation commences.