Supporting the Remaining Chimney Stack Above
Removing the lower part of a chimney breast leaves tonnes of brickwork suspended in the upper floor and roof space. If this masonry is left unsupported, catastrophic roof collapse and wall fracturing will result.
Gallows brackets (triangular steel brackets bolted into party walls) are only acceptable if the remaining stack is no taller than 1.5 metres, the party wall is at least 225mm solid brickwork in good mortar condition, and the neighbour's stack has not been removed. If these conditions are not met, structural engineers specify steel universal beams bearing on padstones.
| Support Method | Acceptability | Average Cost | Best Use Case |
| Structural Steel Beam (RSJ) | Universal Building Control approval | £2,400 - £4,500 | All properties, tall stacks, shared party walls |
| Gallows Brackets | Restricted; subject to council approval | £1,600 - £2,800 | Short stacks, solid masonry, low weight |
| Complete Stack Removal | Universal approval (removes roof stack) | £3,800 - £6,500 | Eliminates all future stack maintenance and leaks |
- Steel beam support: Parallel universal beams spanning between party walls and internal spines.
- Gallows brackets limitations: Prohibited by many councils on shared 9-inch party walls.
- Flue ventilation: Unused chimney flues must be fitted with air grilles to prevent damp rot.
- Corbel testing: Propping with strongboy jacks is compulsory during demolition.
Party Wall Act Requirements for Chimney Removal
In semi-detached and terraced homes, chimney breasts are built directly into or against the shared party wall. Cutting away masonry corbels and drilling pockets for padstones or bracket bolts affects the shared structure.
Homeowners must serve a formal Section 2 Party Wall notice on adjoining neighbours at least two months before starting demolition work. A schedule of condition records the neighbour's decorative state prior to knocking bricks down.
Building Control Inspections and Damp Prevention
Building inspectors inspect the temporary propping (Acro props and Strongboy needles) before the lower masonry is dropped. They re-inspect after structural steel beams and padstones are bolted in place.
Because old chimney flues carry corrosive soot deposits containing hygroscopic salts, remaining chimney brickwork must be treated with salt-neutralising primer before plastering. Ventilated capping pots on the roof prevent rainwater ingress.